Hotpoint Ariston MH 99.1 /HA Instrucciones De Uso página 15

Connecting the supply cable to the mains
Install a standardised plug corresponding to the
load indicated on the data plate. When connecting
the cable directly to the mains, install an omnipolar
circuit-breaker with a minimum contact opening of 3
mm between the appliance and the mains. The
omnipolar circuit breaker should be sized according
to the load and should comply with current
regulations (the earth wire should not be interrupted
by the circuit breaker).
The supply cable should be positioned so that it
does not reach a temperature of more than 50°C with
respect to the room temperature, anywhere along its
length.
Before making the connection, check that:
• The electrical safety of this appliance can only be
guaranteed if the cooker is correctly and
efficiently earthed, in compliance with regulations
on electrical safety. Always ensure that the
earthing is efficient; if you have any doubts call in
a qualified technician to check the system. The
manufacturer declines all responsibility for
damage resulting from a system which has not
been earthed.
• Before plugging the appliance into the mains,
check that the specifications indicated on the
date plate (on the appliance and/or packaging)
correspond to those of the electrical mains
system of your home.
• Check that the electrical capacity of the system
and sockets will support the maximum power of
the appliance, as indicated on the data plate. If
you have any doubts, call in a qualified
technician.
• If the socket and appliance plug are not
compatible, have the socket replaced with a
suitable model by a qualified technician. The
latter, in particular, will also have to ensure that
the cross section of the socket cables are suitable
for the power absorbed by the appliance. The use
of adapters, multiple sockets and/or extensions,
is not recommended. If their use cannot be
avoided, remember to use only single or multiple
adapters and extensions which comply with
current safety regulations. In these cases, never
exceed the maximum current capacity indicated
on the single adapter or extension and the
maximum power indicated on the multiple
adapter.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
N L
! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).
! The manufacturer declines any liability should
The manufacturer declines any liability should The manufacturer declines any liability should
The manufacturer declines any liability should The manufacturer declines any liability should
these safety measures not be observed. these safety measures not be observed. these safety measures not be observed. these safety measures not be observed. these safety measures not be observed.
Oven size
width
depth
Height
Electric oven size:
Voltage end frequency:
50Hz
Power supply Max:
This appliance conforms with the following
European Economic Community directives:
- 2006/95/EEC of 12/12/06 (Low Voltage) and
subsequent modifications;
- 2004/108/EEC of 15/12/04 (Electromagnetic
Compatibility) and subsequent modifications;
- 93/68/EEC
modifications.
- 2002/96/CEE and subsequent modifications.
- 1275/2008 stand-by/offmode.
ENERGY LABEL
Directive 2002/40/EC on the label of electric ovens
Norm EN 50304
Declared energy consumption for Forced convection Class
heating mode:
54cm
38cm
33cm
L. 68
220-240V /
2800W
of 22/07/93 and subsequent
Gratin
GB
15