KALLISTA P30901-00 Guia De Instalacion página 7

Wall Plate
Tissue Holder
Assembly
Screw
Setscrew
P30908-00
5. Install the Tissue Holder
For P30908-00 Model
Vertically and horizontally align the wall plate. Ensure the flange
of the wall plate is facing down.
Mark the four hole locations with a pencil, then set the wall plate
aside.
Select a drill and 5/16" drill bit appropriate for the wall material
you will be drilling through.
Carefully drill a 5/16" hole at all marked pilot hole locations.
Press and hold the legs of a wall anchor together, then insert the
wall anchor legs into the hole. Insert all wall anchors into the
pre-drilled mounting holes.
Carefully tap each wall anchor into the finished surface until
flush.
NOTE: If the wall anchor was inserted into a space between the
studs, it will be necessary to spread the wall anchor legs. Insert a
thin, long object (such as a finishing nail) into the wall anchor hole
to spread the anchor legs.
Horizontally align the mounting holes on the wall plate with the
installed anchors, as shown.
Secure the wall plate with the supplied screws.
Partially thread two setscrews into the bottom of the tissue holder
assembly.
Kallista
Wall Plate
Setscrew
Roller
P32008-00
7
Tissue Holder
Assembly
Cover
Roller
1008325-2-A