Checking Tire Pressure; Adding Oil And Fuel; Engine Fluid Requirements; Adding Engine Oil - Generac GC2800B Manual Del Propietário

20. See Figure 2-18. Install cable ties (K) to secure
wire harness (L) to handlebar. Verify cables are not
on top of handlebar, where they can interfere with
starter pull cord (M). Wear eye protection when
cutting excess ends of cable ties using wire cutters.
M
Figure 2-18. Install Cable Ties

Checking Tire Pressure

Proceed as follows to check tire pressure:
1. See Figure 2-19. Remove valve stem protective
cap (A) and check tire pressure with a tire pressure
gauge.
A
Figure 2-19. Checking Tire Pressure
2. Compare tire pressure reading with manufacturer's
recommended tire pressure stamped on the side of
the tire.
3. If tire pressure is too low, add air through valve
stem with an air hose.
4. Replace valve stem protective cap when finished.
Owner's Manual for Snow Blower
L
K

Adding Oil and Fuel

Engine Fluid Requirements

Above -30 °F (-34 °C): 5W-30 or 0W-30
Engine Oil*
-13 °F (-25 °C) or below: 0W-30
Fuel Unleaded gasoline. Minimum 85 octane rating.
* Use only high detergent oil classified "For service SF, SG, SH,
SJ" or higher. Do not use special additives. See engine
owner's manual for detailed engine information, including oil
and fuel quantities and cold temperature oil specifications.

Adding Engine Oil

Fire and explosion risk. Keep spark and flame
away from liquid and vapor. Do not smoke while
using. Doing so could result in death, serious
injury, or equipment damage.
011065
Skin irritation. Avoid prolonged or repeated contact with
used motor oil. Used motor oil has been shown to cause
skin cancer in laboratory animals. Thoroughly wash
exposed areas with soap and water.
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
Personal injury. Wear appropriate personal protective
equipment at all times while operating and servicing
unit. Failure to do so could result in personal injury.
IMPORTANT NOTE: The unit is shipped without oil in
engine. Traces of oil may be in reservoir from factory
testing. Oil must be added prior to initial operation.
011067
Use only the recommended high detergent engine
oil. See Engine Fluid
Proceed as follows to add engine oil:
1. Place unit on a firm, level surface. Verify engine is
cooled.
General Information and Setup
WARNING
WARNING
CAUTION
CAUTION
Requirements.
(000341)
(000210)
(000135)
(000419)
11