Publicidad
Idiomas disponibles
Idiomas disponibles
InStAll thE lEFt SIdE BRACkEt
Remove the left Side hardware
1.
Remove the following from the left side of the upper handle,
Figure 5. The hardware removed can be discarded.
•
Two 1/4-20 screws
•
Two flat washers
•
Two 1/4-20 cap lock nuts
Install the left Bracket
2.
Align holes in rod bracket [E] with holes in panel while placing end
of rod assembly [C] through the bracket. Secure with the following
items from the hardware pack, Figure 6:
•
Two 1/4-20 x 1.75" screws [F]
•
Four flat washers [H]
•
Two 1/4-20 cap lock nuts [G]
ASSEMBLY AND OPERATION
Figure 5
E
H G
C
H
F
Figure 6
ASSEMBlE thE GRASS BAG
1.
Place grass bag [A] over chute assembly [B], Figure 7.
2.
Use the cable tie [I] to secure bag to chute assembly by inserting
the cable tie into hole in bag and pulling through. Make sure cable
is positioned so it ties bag around indented groove (over flange)
of chute, Figure 7. Pull cable tight with pliers.
A
AttACh thE Rod hAnGER
1.
Insert rod hanger [D] into the opening in the rod assembly [C],
Figure 8.
2.
Slide the tabs on the grass bag over the bag hanger rod, Figure 8.
D
Tabs
I
B
Figure 7
C
Figure 8
Publicidad
