Setup Instructions; Install Batteries - General SEEKER 312 Manual Del Usuario

A
B
C
Fig. 2. The controls, indicators and connectors
of the DCS312
A. Lens cap
B. Camera head and LED lights
C. 12mm flexible-obedient probe
D. LCD
F. button. Increases brightness of LED lights
G. button. Inverts video 180°
H. button. Decreases brightness of LED lights
I. button. Enlarges video frame up to 2X. Each press of button increases zoom
level by 10 or 20%, relative to real size
J. button. Powers unit on and off

SETUP INSTRUCTIONS

INSTALL BATTERIES

The DCS312's battery compartment is accessible
from the bottom of the grip (Fig. 2, Callout E).
To install batteries,
1. Use a Phillips-head screwdriver to loosen the single
screw securing the battery compartment cover.
Remove the cover and set it aside.
2. Extract the battery magazine from the grip by pulling
on the tab at its end (see top figure).
3. Load four "AA" batteries into the magazine, using
the polarity markings within it as a guide (see bottom
figure).
4. Push the loaded magazine back into the grip (it fits
only one way).
5. Replace the battery compartment cover and secure it
to the grip by tightening the Phillips-head screw.
D
E. Battery compartment (on bottom of grip)
F
G
H
E
K. VIDEO OUT jack (behind LCD)
K
I
J
5