PowerFit PF31023B Instrucciones De Instalación

15 in. Surface Cleaner Attachment
PF31023B
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their pressure washer before us-
ing this accessory. To reduce the risk of injury or property
damage, spray the pressure stream in a safe direction to
ensure proper connection of all accessories before starting
any cleaning project. Fits most pressure washers. Ensure
compatibility and proper fit before using this accessory.
Wear eye protection with side shields marked to comply with
ANSI Z87.1. Risk of fluid injections; do not point at people,
pets, electrical devices or the unit itself. Turn off the pressure
washer, relieve the water pres sure in the trigger handle, and
lock the lock out on the trigger handle (if one is included
with your pressure washer) before installing, changing, or
adjusting accessories. For cold water use only. For outdoor
use only – store indoors. Save these instructions. Refer to
them frequently and use them to instruct other users. If you
loan someone this tool, loan them these instructions also.
PRODUCT SPECIFICATIONS
Connections ..................................1/4 in. Quick Connect Plug
Deck Width ...................................................................... 15 in.
Maximum Pressure ..................................................... 3300 psi
Maximum Water Flow .....................................................3 gpm
Maximum Water Temperature .........................................140°F
INSTALLING THE SURFACE CLEANER ON THE
SPRAY WAND
See Figure 1.
Insert the surface cleaner inlet plug into the spray wand quick
connect coupler and secure.
WARNING:
To reduce the risk of injection or injury, only use the surface
cleaner on flat, horizontal surfaces. Never lift the surface
cleaner from the cleaning surface while operating the pres-
sure washer.
USING THE SURFACE CLEANER
See Figure 2.
WARNING:
Do not reach hands or feet under cleaning deck. Contact
with the spinning nozzles or spray bar can result in a fluid
injection or other serious personal injury.
n Once the surface cleaner is installed, connect the hose to
the pressure washer as described in your pressure washer
manual.
n Start the pressure washer as described in your pressure
washer manual.
INLET
PLUG
n Walk slowly behind the cleaning deck, cleaning as you go.
NOTE: If striping or swirling occurs, slow your pace. If strip-
ing or swirling continues, the surface cleaner nozzle(s) may
be clogged. See Nozzle Maintenance for how to clean the
nozzles.
WARNING:
Do not use the surface cleaner on raised obstacles. Strik-
ing any raised obstacle while using the surface cleaner will
damage the unit. If contact does occur and causes vibration
when operating the pressure washer, stop and discontinue
use. Continuing to operate the unit could result in serious
injury or damage to the unit.
QUICK CONNECT
COUPLER
Fig. 1
Fig. 2