Haier HSU-24H03/Z Manual De Funcionalmiento página 11

stallation Manual of Room Air Conditioner
Operation
TIMER ON-OFF
TIMER ON-OFF
(1)After unit start, select your desired operation mode
Necessary Tools for Installation
Operation mode will be displayed on LCD.
Power indicator on indoor unit lights up.
ver
(2) Press TIMER button to change TIMER mode.
cksaw
le core drill
Every time the button is pressed, display changes as follows:
anner(17,19 and 26mm)
ON
TIMER ON
ssory parts
Select TIMER ON-OFF. "ON" will flash.
Number
ssory parts
of
articles
(3)Time setting for TIMER ON
1
mote controller
Press HOUR button.
2
Every time the button is pressed, time increases 10 min.
R-03 dry battery
If button is kept depressed, time will change quickly.
Mark
Every time the button is pressed, time decreases 10 min. 1
A
If button is kept depressed, time will change quickly.
Mounting plate
B
1
Time will be shown on LCD.
C
Drain hose
It can be adjusted within 24 hours.
D
4
AM refers to morning and PM to afternoon
5
E
Plastic cap
(4) Time confirming for TIMER ON F
1
Drain-elbow
G
After time setting, press TIMER button to confirm.
"ON" stops blinking, While "OFF" starts blinking.
4
Cushion
Time displayed: Unit starts at x hour x min.
1
e supporting plate
(5)Time setting for TIMER OFF
1
Follow the same procedures in "Time setting for TIMER ON".
onnecting cable
(6) Time confirming for TIMER OFF
After time setting, press SET button to confirm, "OFF" stops flashing
Time displayed: Unit stops at X hour X min.
To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
The marks from
The distance between the indoor unit and the floor should be
more than 2m.
Read this manual before installation
Explain sufficiently the operating means to the user
according to this manual.
5.Torque wrench(17mm,22mm,26mm)
6.Pipe cutter
7.Flaring tool
8.Knife
OFF ON
TIMER OFF TIMER ON-OFF
Drawing for the installation of indoor and outdoor units
Optional parts for piping
Parts name
Non-adhesive tape
Adhesive tape
Saddle(L.S) with screws
Connecting electric cable
for indoor and outdoor
Drain hose
Heating insulating material
Piping hole cover
Arrangement of piping directions
Rear left
Rear
Left
right
Right
Below
to in the figure are the parts numbers.
A G
9.Nipper
10.Gas leakage detector or
11.Measuring tape
blank
OFF
The models adopt HFC free refrigerant R410A
10
soap-and-water solution
ON/OFF
MODE
FAN
SWING
SLEEP
LOCK
Attention must be paid to
the rising up of drain hose
12.Reamer
ON
TEMP
1
SET
6
3
TIMER
5
4
2
CLOCK
RESET