sunjoe GTS4001C Manual Del Operador página 20

Fig. 34
2. To turn the pole blower ON, push and hold the safety lock
switch (located on the handle) forward with your thumb
and then squeeze the On/Off switch with your fingers.
Once the tool is running, you can release the safety lock
switch (Fig. 35).
Fig. 35
3. To turn the tool OFF, release the On/Off switch (Fig. 35).
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which can
telescope from 3.7 ft (1.1 m) to 5.3 ft (1.6 m). To adjust the
telescoping pole, follow the instructions below.
1. Disconnect the blower from the power supply by removing
the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 36).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the leaf/debris.
Fig. 36
Pull
Telescoping lock
3. Lock the pole in position by closing the telescoping lock
(Fig. 37), and ensure that the pole is secured.
Battery
Safety lock
switch
On/Off switch
Pull
Fig. 37
m
WARNING!
Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The pole leaf blower head can be rotated for 10 different
cutting angles for -30º, -15º, 0º, 15º, 30º, 45º, 60º, 75º, 90º,
and 105º. Follow the below instructions to adjust angles.
1. Rotate the leaf blower head to desired angle while
pressing the rotating buttons located on both sides of the
unit simultaneously (Fig. 38).
Fig. 38
Rotating buttons
Front side
2. Release the buttons when the leaf blower head is fixed
into the desired angle.
NOTE: Failure to properly secure the blower head may
result in personal injury and/or property damage.
m
WARNING!
Always ensure the blower head is securely
locked! Do not attempt to use the pole leaf blower with the
head in any other position or unlocked!
Adjusting the Auxiliary Handle
The leaf blower is equipped with an auxiliary handle that can
be adjusted and removed. Follow the instruction below to
operate the auxiliary handle
m
WARNING!
Make sure the knob, bolt, and the screws
are fixed into place. Failure to lock any of them as directed
could result in personal injury or property damage.
20
Telescoping lock
Back side