iCraig CMP756 Manual Del Propietário página 8

Notes:
A. Insert the card (Up to 32GB, not included) into the card slot on left side of unit with metal chip face
up.
B. To take out the card, press the card until a "Touch" is heard then pulls out the card.
C. Before replacing the storage card, make sure the unit has been powered off.
D. When inserting the storage card, make sure the direction you select is correct. Never insert
violently to avoid damaging the card or the unit. If the storage card doesn't work, please check if
the direction is correct.
E. When the card is used for the first time, or it has been used in another device, please format it first
through the Computer. You also need to download the desired music, photos and/or movie onto
the card before installing into the unit
Important: Formatting the Micro SD Card will delete all the data on the card. Download the data
to your computer before formatting the card.
Micro USB Port (USB OTG)
This device supports USB device for extending the memory size, or USB Thumb Drive, inserts the
supplied USB cable (micro USB plug to Full size USB female jack) into the micro USB port on the side
of unit. Insert USB device into Full size USB female jack, like in the PC.
Notes:
Before replacing a USB drive, make sure the unit has been powered off.
A.
B. When inserting the USB driver, make sure the direction you selected is correct. Never insert
violently to avoid damaging the USB driver or the unit. If it doesn't work, please make sure if the
direction is correct.
Power on/off the Device
Press and hold the
Touch and slide the key bar shown on the screen to top to unlock
In power on mode, press the
again to turn it on.
To power off the device, press and hold the
the "OK" button as on screen instruction to power off the unit.
Notes:
A.
Like your computer, after turning on the device, you may have to wait a short while to let the
operating system boot up before the home page appears on the screen.
Reset:
If the device becomes abnormal, halts, freezes. Press the RESET Button in the reset hole on the rear of
device (see figure as below) with a small screwdriver (not included) to reset the device.
button on the top cabinet approximately 4 seconds to power on the unit.
button to turn off the screen for saving battery power. Press
button until the "Power off" window pop up, touch
8