Cleaning And Maintenance - NORAUTO 2271067 Manual Del Usuario

DIVIDING THE COMPRESSOR COOLER INTERIOR
The compressor cooler compartment is supplied with a removable divider. This divider
can be easily removed by lifting it vertically. When refitted, the divider must be located
between the ribs on the sides of the compressor cooler compartment.

CLEANING AND MAINTENANCE

• WARNING: Always disconnect the device from the power supply before cleaning or
maintenance.
• Never immerse the unit in water or other liquids.
• Wipe interior and exterior with a damp cloth and neutral cleanser.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can
damage the product.
• Keep the ventilation slots free of any dust and dirt, so that heat can be released and
the device is not damaged.
• To clean around the motor surround, place the compressor cooler in a well-ventilated
area and use a vacuum cleaner or a gentle stream of compressed air.
• WARNING: Under no circumstances is the motor surround to be removed.
DEFROSTING
Periodically ice may form on the inside of the compressor cooler. This will reduce its
capacity and cooling efficiency. Defrosting your compressor cooler regularly will keep
the compressor cooler at peak operating condition.
1. Turn off the compressor cooler.
2. Disconnect compressor cooler from DC power supply.
3. Remove all contents and removable spacer.
4. Open the lid to allow the interior compartment to warm up to ambient air temperature.
5. As ice melts, soak up the water with a clean towel.
6. Once all ice has melted, clean the interior.
7. Let it dry completely.
CAUTION: DO NOT use hard, sharp or pointed objects to defrost the compressor
cooler or loosen items that have become frozen in place. Irreparable damage to cooling
system can occur.
STORING
• Carefully wind up the DC power cord and store it in a dry place.
• Ensure the inside is fully dry before storing when not in use.
• Store the appliance in a cool, dry place, protected from moisture and direct sunlight.
• When not in use the cooler's lid shall be left ajar to prevent mould growth and
unpleasant odours.
EN
47