Marineland ECLIPSE1 Guía De Instalación Rápida

Start Here -
1
Verify The Contents
Cord Organizer
Filtration Area
Eclipse Filter
Cartridge
Lighting Area
Rite-Size
Cartridge sticker
3
Assemble Filter
A. Attach Intake/Pump
Assembly to Motor
Assembly. Install
inside Hood.
Allow your System to operate for 24 hours before adding any fish.
Adding Fish:
Start with just 1 or 2, adding more gradually over a 4-6 week period. Some fish require a heater.
Questions or missing parts? Call customer service at (800) 322-1266 or visit www.marineland.com.
E , E
CLIPSE CLIPSE
1
Flexible
Motor Assembly
Pump
Mount
Intake/Pump
Assembly
BIO-Wheel
Hood
Install Filter Cartridge (blue side up).
D.
Reinstall Filtration Access Panel.
Mount BIO-Wheel
Remove paper B.
in special pin holders.
from BIO-Wheel.
and E
CLIPSE
2
2
A. Add decor to aquarium.
Place Hood on top of aquarium.
B. Unlock Filtration Access Panel by sliding
Filtration Access
Hinge Pins inward toward center of panel.
Panel
Remove panel and set aside.
Hinge Pin
4
C. Rinse Filter
Cartridge.
Light
Switch
Quick Setup Guide
3
Prepare Aquarium
Flow Diverter
C. Add water and conditioner.
Adjust Flow Diverter angle as
desired. DO NOT adjust past
Filtration
90°. . .water may spill out of tank.
Area
Rout Cords
A. Rout lighting power
cord inside hood.
Remove red covering from
B.
adhesive strips on Cord Organizer.
Attach to outside of aquarium.
Allow adhesive 24 hrs to set.
C. Rout all cords along back
side of aquarium inside
Cord Organizer.
Lighting
Area
NOTE: Drip Loop
(for safety)
8/04 10976