Led Display; Important - mspa Mono F-MO061 Manual Del Propietário

ALL-IN-ONE CONTROL PANEL

LED display

Heater Button
Bubble Button
- Adjust the bubble level by
pressing the button
(L1:300W, L2: 500W, L3:720W)
Ozonator Button
LED display
°C
°F
Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically.
NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as approximately 1°C.
HEATING
1. Press the HEATER button to turn the heating system on/off. The HEATER icon shown on the LED display means the heating system is
HEATER
HEATER
activated. The flashing HEATER icon means the spa is at the set temperature and the heating system is at rest.
UP DOWN
°C 2. Pressing the
20-40
UP
temperature setting will remain on the LED display for 3 seconds to confirm the new value.
NOTE: The default temperature is 38°C.
NOTE: If the heating system is turned on, the filtration system will automatically start.
NOTE: When the water temperature is below 1°C (33.8°F), the anti-icing system will be activated automatically to heat the water to 3°C (37.4°F).
IMPORTANT: The following conditions will lead to slow water heating
● An ambient temperature lower than 10°C (50°F).
● An outdoor wind speed above 3.5-5.4m/s (8-12mph).
● If the air bubble function is activated when the heater is on.
● If the spa cover is not properly in place when the heater is on.
FILTRATION
Press the FILTER button to turn the function on/off. The FILTER icon shown on the LED display means the function is activated.
FILTER
FILTER
NOTE: The filtration system will automatically start when the heating, Ozone or UVC sanitizing system is activated.
NOTE: After turning off the heating system, the filtration system will automatically stop in 30 seconds.
Filter Cartridge Cleaning Reminder: When the FILTER icon flashes continuously, the filter cartridge must be cleaned or replaced. Once this
has been done, press the FILTER button for 3 seconds to reset the reminder.
UP or DOWN button to adjust the water to the desired temperature setting (from 20°C to 40°C ). The new and desired
DOWN
Down Button Up Button
14
Lock
Filter Button
Timer Button
UVC Button
Unlock