Maintenance And Storage - Famastil F-Power P1111.350 Manual De Instrucciones

02
Insert the line through the "brass" holes
on the spool holder, pull line out. Push
spool inwards against the spring clip and
then push spool cover firmly downwards
until it locks into position and at the same
time pull lines and be sure that they are
released from spool rail notches. If not,
the bumping-feed will not operate. Follow
the instruction on cutting the line in
"Preparing the trimmer for use" section 1
before use. (see FIG9)
TO REWIND THE SPOOL WITH NEW LINE
The trimmer line must not
exceed the thickness of 1,6mm.
01 Insert the line through a hole in the
spool and secure it. (See FIG17)
02 Snugly and evenly wind the cutting
line onto the spool in the direction of the
arrow on the spool until the line builds
up to the notches in the spool rim. Do not
overfill spool. (See FIG18)
03 Repeat to replace the other cutting line.
04 Insert the line through the 'brass'
holes on the spool holder, pull line out.
Push spool inwards against the spring
clip and then push spool cover firmly
downwards until it locks into position.
Follow the instruction on cutting the
line in 'Preparing the trimmer for use'
section 1 before use. (See FIG20)
01
Your trimmer requires no additional lubrication or maintenance. There are no user
serviceable parts in your trimmer.
02
Never use water or chemical cleaners to clean your trimmer.
Wipe clean with a dry cloth.
03
Always store your trimmer in a dry place.
04 Keep the motor ventilation slots clean.
If you see some sparks flashing in the ventilation slots, this is normal and will not
05
damage your power tool.
26

MAINTENANCE AND STORAGE

FIG 17
line
FIG 16
FIG 18
FIG 19
FIG 20