Cool Factor; Lost Balance Time; Drum Time - Primer DSD-11 Guía Rápida De Manejo

1.2.3.1.7
After all the temperature settings have been defined, the cooling time to the end of the cycle
should be configured. The Cool Factor parameter defines the length of this cooling. The factory
setting is 0 but this can be modified. Use the INC () and DEC () keys to modify the value, and
the SELECT key to confirm the modification.
IMPORTANT! THE COOL DOWN MINUTES ARE INCLUDED IN THE SELF-SERVICE
1.2.3.1.8
This parameter defines the time in minutes that the dryer can remain inoperative (fan not
running) before any outstanding balance is lost. The factory value is 0, with this value this
function is deactivated, and therefore the outstanding balance is never lost. To insert a different
value, use the INC () and DEC () keys to modify the value, and the SELECT key to confirm the
modification.
1.2.3.1.9
This option allows the time in seconds that the programmer waits before changing the
direction of the drum rotation to be adjusted. The value entered remains fixed over time for all the
programs. To modify the configuration, use the INC () and DEC () keys to increase or
decrease the time and the SELECT key to confirm the change and go to the next option.
Note: Values below 30 seconds should not be entered.
30

COOL FACTOR

COOL FACTOR
001.
PROGRAMME TIME

LOST BALANCE TIME

LOST BAL. TIME
000.

DRUM TIME