Worx WG508 Manual De Instrucciones página 10

tool before separating the tube.
AttACHiNg tHE LEAF CoLLECtioN BAg
(See Fig. g1-g2)
This machine is equipped with a Leaf
collection Bag, which is designed for
collecting leaves and debris. Attach the Leaf
collection Bag as show in Fig. G1 –Align Leaf
collection Bag collar slots with the locking
pins on the Motor Housing. Push the collar up
into position then rotate the Leaf collection
Bag housing counter-clockwise –ensure the
Leaf collection Bag is locked into position and
fully secured.
NotE: The size of the locking pins on the
Motor Housing is different, when assembling
the Leaf collection Bag, please align the bag
collar slots with the corresponding locking
pins.
opErATIoN
CoNNECtiNg to A PowEr SourCE
Use only a polarized (i.e., one blade is wider
than the other), UL listed (cSA certified in
10
canada) extension cord recommended for
outdoor use. A polarized plug will fit in a
polarized cord only one way. If the plug does
not fit fully in the cord, reverse the cord and
try again. If it still does not fit then you are
not using a proper extension cord and you
should purchase a polarized extension cord.
Never attempt to force fit an extension cord or
change the cord's design to make it fit better.
Extension Cord
Length
100 ft.
150 ft
NotE: do not use an extension cord over
150 feet.
if you do not fully seat the extension
cord on the inlet plug, the loose plug
could lead to overheating and cause a
fire, possibly burning you or others.
Ensure that you fully seat the cord on
the plug and use the cord lock feature to
secure the cord.
iMPortANt: check the power cord
Blower/Vac/Mulcher
Minimum wire
gage (A.w.g.)
14
12
frequently during use for holes in the
insulation. Do not use a damaged cord. Do not
run the cord through standing water or wet
grass.
Cord Hook
There is a cord Hook on the rear of the Motor
Housing.
To use the cord Hook as shown in Fig. H, hook
the extension cord through the handle. Then
plug the cord from the Motor Housing into the
extension cord.
StArtiNg/StoPPiNg (See Fig. i)
iMPortANt: The machine will not run unless
the Vacuum Tube or the Fan cover is attached
to the Motor Housing.
StArtiNg
Your Blower Vac is fitted with a 2-speed switch
located on the handle. connect the plug to the
power outlet and switch ON by moving the
On/Off switch to position"I" , move to position
"II" , the air speed will increase.
StoPPiNg
Move the On/Off switch to position "O" .
wArNiNg! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down or removing the
Leaf collection Bag.
uSiNg tHE BLowEr (See Fig. J)
The blower is intended for residential use
only. Use the blower outdoors to move yard
debris as needed.
CAutioN!
the blower can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
- do not blow hard objects such as nails,
bolts, or rocks.
- do not operate the blower near
children, bystanders or pets.
- use extra care when cleaning debris
from stairs or other tight areas.
- wear safety goggles or other suitable
eye protection, long pants, and shoes.
Ensure product is switched off and
disconnected from the power supply.
Attach the Blow Tube, for assembly
EN