Assembly And Operation - Worx WG471 Manual Del Usuario

OPERATION INSTRUCTIONS
NOTE: Read instruction handbook before
operation this machine.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the handle bar
NOTE: Choose one of the two
holes in the upper handle for
desired handle's height when
attaching the upper handle.
Do not over tighten the handle
locking knob in case it cannot
be locked.
IMPORTANT: When attaching
the middle handle, make
sure the chute rotation shaft
mounting hole on the middle
handle is facing downwards
(side of bar where hole is
indented).
Using the cable clips
Assembling the chute crank
NOTE: Make sure the chute
rotation shaft rest below the
middle handle.
Assembling the discharge chute
NOTE: When attaching, make
sure the discharge chute fully
seated into position and gently
pulling it outwards to make
sure it is locked into position
securely.
Cordless Snow Thrower
Adjusting throw direction and
throw height
NOTE: The discharge chute
can be adjusted 180 degrees
by rotating the chute rotation
handle.
chute at the operator, at
FIGURE
bystanders, at vehicles or at
nearby windows. The
discharged snow and foreign
objects accidentally picked
up by the snow thrower can
cause serious damage and
personal injury. Always
orient the discharge chute in
the opposite direction from
where you, bystanders,
See Fig. A1-A6
surrounding vehicles, or
windows are located.
WARNING: Make sure that
the chute deflector snaps
and locks completely
onto the discharge chute.
An opening between the
discharge chute and the
chute deflector may allow
See Fig. B
foreign objects to be picked
up by the snow thrower and
thrown in the direction of
See Fig. C1-C3
the operator causing serious
boldly injury.
Do not advance the chute
deflector too far forward
causing an opening to
appear between the chute
See Fig. D1, D2
deflector and discharge
chute.
Checking the battery charge
condition
Charging the battery pack
NOTE: The battery is shipped
uncharged. The battery must
be fully charged before the first
mow.
Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Fitting/Removing battery
NOTE:
This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
WARNING: Never direct
the snow discharge
See Fig. E1, E2
15
See Fig. F
See Fig. G
See Fig. H
EN