Fagor HTT 102 Manual Del Usuario página 18

1) DVB-T: modulating standard; XX.XXX M: the current output frequency; U: symbol of the
USB disk insertion; 1080i: video resolution of signal source; X.XX Mbps: the current encoding
bit rate
2) Alarm Status: For example, if the signal cable disconnected, it will display Video 1 Not Lock
under this menu.
3) Uptime: It displays the working time duration of the device. It times upon power on.
4) Encoder parameters: Video in Status: User can view the video status under this menu.
Resolution: signal source resolution (read only). Video Bit rate: adjust in the range of 1.000 ~
18.000 Mbps. Audio Bit rate: Select audio bit rate among 64, 96, 128, 256, 320Kbps. Audio
Format: Select audio format among MPEG2, MPEG2-AAC.
5) Stream: User can view or adjust TSID (Transport Stream ID), ONID (original Network ID),
Network ID, Network Name, Provider Name, Program Number, LCN (Logical Channel Number),
PMT PID, Video PID an Audio PID after enter this menu.
6) Country: User can select default configuration, Australian or New Zealand configuration.
7) Channel: User can choose the output frequency channel under this submenu.
8) Bit Rate: User can read the current modulation bit rate and the maximum bit rate.
9) RF Frequency: Adjust it at range of 142,5 to 858 MHz. Set it according your regional
situation or inquire your local services.
10) Bandwidth: Select among 6M, 7M and 8M.
11) Constellation: DVB-T modulator contains 3 constellation modes: 64QAM, QPSK and
16QAM.
12) FEC: Forward Error Correction rate. It contains 1/2, 2/3, ¾, 5/6 and 7/8.
13) FFT (Transmission Mode): Select between 2K and 8K.
14) Guard Interval: Select among 1/32, 1/16, 1/8 and 1/4.
15) RF Level: Adjust in a range of -14 ÷ +6dBm.

NOTE: The different combination of bandwidth, constellation, guard interval and code
rate (FEC) will form a different output code rate. Please refer to appendix table 1.
16) Save Config: Yes or No, to save or give up the adjustment of setting.
18