Auto Shut-Off; Cleaning & Maintenance - Revamp BR-2000 Manual Del Usuario

• The selected digital temperature display will flash until the brush has reached the
temperature wanted. Once the temperature has been reached the LED light will remain
static.
• Run the brush through your hair as you would with a traditional brush, starting from
the roots and moving towards the ends in a single movement:
- In a linear manner for poker straight results
- With the heated bristle plate and bristles facing towards you or outwards
according to the movement wanted.
• After use, switch off the brush, unplug, place on the REVAMP heat resistant mat and
allow to cool before storing away.
Follow us on www.revamphair.com for the latest hair tips and advice.
Please note:
• This is a high-performance product, avoid frequent use to prevent hair damage.
• Regular use of styling products may deteriorate the surface coating over time.
• Do not scratch the surface of the product as this will deteriorate the effectiveness of
the coating.
• While heating, during use and cooling, place on the REVAMP heat resistant mat. Only
hold unit at the end of the handle.
• The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.

AUTO SHUT-OFF

This appliance has an automatic shut off feature for added safety. If the appliance is
switched on for more than 60 minutes
continuously, then it will automatically
switch off. If you wish to continue using the
appliance after this time, press the power
button to switch on. Use the temperature
control to select your desired temperature.
This feature should not be considered as a
substitute for 'OFF'. ALWAYS REMEMBER TO
SWITCH THE APPLIANCE OFF AND UNPLUG
FROM THE MAINS WHEN NOT IN USE.
PLUG (BR-2000-GB ONLY)
This unit comes with a removable UK 3-pin plug. The 3-pin plug can be removed to reveal a
European 2-pin plug by unscrewing the centre screw, lifting the rear cover and unclipping
the European 2-pin plug. It can be replaced if necessary, by reversing this procedure. If
required replace plug fuse with one the same value
If the plug on this appliance is damaged, it can be replaced with a BS 1363 plug, fitted
with a BS 1362 fuse. Please use the same value of fuse supplied. Care must be taken when
changing the plug. If in doubt, contact a qualified electrician.
CLEANING & MAINTENANCE
• Switch the appliance off, unplug from the mains and allow to cool fully before
cleaning.
• Wipe over all surfaces using a soft damp cloth. Do not use harsh abrasives or cleaners.
• When the heated brush is completely cool remove any loose hairs from the bristles
after every use and make sure there is no product build up on the ceramic barrel or
bristles.
• Do not immerse the appliance in water or any other liquid.
• Ensure all parts are dried thoroughly with a soft towel before reusing.
• To prevent cord damage, do not wrap the cord around the appliance, always store the
cord loosely next to the appliance.
• Store in a cool dry place.