HoMedics DUAL TEMP PERCUSSION PRO HHP-500H Manual De Instrucciones E Información De Garantía página 4

2. To turn the unit on, simply press the POWER
the unit on the lowest setting. To increase the intensity of the massage, continue to press the POWER
button until the desired intensity is reached. To turn the unit off, continue to press the POWER
past the highest intensity setting, which will reset the intensity cycle and power the unit off (Fig. 1).
3. To turn the heat function on, press the HEAT button located below the power button on the handle
(Fig. 1). To cancel the heat function, press the HEAT button a second time.
4. To turn to cooling function on, press the COLD H button located below the power button on the handle
(Fig.1) To cancel the cooling function press the COLD H button a secound time.
NOTE: The heat cooling function works best when the attachments are removed and the metal nodes are exposed.
NOTE: Do not use the heat/cold continuously for more than 15 minutes. Do not use the heat/cold if you
have sensitive skin, poor circulation, discolored areas, swelling, burned, inflamed or where skin eruptions
or sores are present. Heat/cold should be pleasant and comfortable. Should pain or discomfort result,
discontinue use and consult your physician.
5. Apply massager head lightly to the area you wish to massage.
6. Move the unit slowly, holding on the targeted area. Massage the area for a short period of time and
move to another area. Never massage the same spot longer than 3 minutes. CAUTION - as stated in the
"IMPORTANT SAFETY INSTRUCTIONS" section of this manual, never use this appliance on or near eyes or
other highly sensitive areas.
7. Operation of longer than 15 minutes is not recommended and may cause overheating.
8. When massage is completed, turn unit off, unplug the power supply, allow to cool and store properly in a dry place
TO CHANGE ATTACHMENTS
Your massager comes equipped with six custom massage head attachments.
A. Indented
To change to a different set, simply pull attachment off the set that is on the unit, then press on the desired set
MAINTENANCE
TO STORE:
Unplug the appliance from the outlet, and allow it to cool before storing in its box or a clean, dry place. Coil
the cord and secure it with the supplied fastener. Do not hang the unit by the powercord.
TO CLEAN:
Clean only with a soft, slightly damp sponge. Never allow water or any other liquids to come into contact
with the unit.
B. Spiral C. Smooth
button located on the top of the handle. This will start
4
button