Cameo ROOT PAR Manual De Usuario página 13

find tables on channel assignment in the different DMX modes in these instructions under DMX
CONTROL.
--------Menu-------
DMX Address ----DMX Address----
DMX Mode
DMX Address
2CH
001–512 001–512 001–512
DMX Delay
DMX Mode
4CH1
Stand Alone
DMX Delay
4CH2
Slave
5CH
Settings
6CH
System Info
9CH
DMX DELAY
The DMX Delay function allows a chaser light effect to be easily created with any number of
spotlights of the same model and software version, which could otherwise only be achieved with
a suitable DMX controller and complex programming. All spotlights integrated into the setup are
set to the same DMX mode and controlled with the same DMX start address.
Manually set the DMX delay for DMX operating modes without DMX delay channel (2CH,
4CH1, 4CH2, 5CH, 6CH, 9CH):
Starting from the main display, press MENU to go to the main menu. Using the  and  buttons,
now select the DMX Delay menu option and press ENTER to confirm your selection. Use  and
 again to select the desired submenu item, press ENTER to confirm, and set the corresponding
value as desired. Press ENTER to confirm all entries.
Assign the spotlight to one of 47 groups (maximum number of groups depends on the activated
DMX mode). Several spotlights can also be assigned to one group. The group number is also the
factor by which the set delay time is multiplied.
The delay time (delay time of the DMX signal) can be set manually on each spotlight separately
with different values (0.0 s to 2.0 s in 0.1 s steps).
Setup example:
D3CH
D5CH1
D5CH2
D6CH
D7CH
D10CH
13