ENGLISH
REAL SHIELD
This product has been manufactured in following
with the requirements of Regulation (EU)
2016/425, for its basic use, according to
Recommendation for Use RfU PPE-R/03.031
Version 1 based on Recommendation (EU)
2020/403 of the Commission 13 March, 2020
regarding conformity assessment and market
monitoring procedures within the context of the
threat posed by COVID-19, to protect against
drops and splashes which are applicable to it, as
stated in the AITEX certificate nº
21/3474/00/0161, Plaza Emilio Room nº1, Alcoi,
Spain, Notified Body 0161.
This PPE contains the following materials:
−
Large strip: PET grade 40
−
Medium strip PET grade 40
−
Small strip PET grade 40
−
Visor: PETG grade 20
−
Rivet: Aluminium / SS
−
Elastic strap: Neoprene
USE
The integral face shield is placed on the user's
head by adjusting the harness until it is
perfectly positioned, leaving the user's hands
free to carry out operations.
Avoid contamination or injury from liquid
splashes.
CLEANING RECOMMENDATIONS:
It can be easily cleaned using water or an
antiseptic disinfectant with a soft cloth.
MAINTENANCE
To protect the eye protection device, it should
be cleaned after each use or discarded if the
scratched surface impairs vision.
STORAGE:
Each eye protection device is packed in a
paper envelope to protect it from dust and
moisture.
Place back inside the paper envelope when not
in use. If the envelope is not available, store in
a place free from dust and moisture.
Store between 5 and 40ºC, with a humidity
lower than 90%.
PACKAGING:
The unit is supplied in a paper envelope
These envelopes are supplied in cardboard
boxes containing multiple units: 10, 20, 50 and
100.
APPLICATION FIELDS:
Intended to protect the eyes and face during
activities that require protection against drops
and splashes only during the COVID-19
emergency. This face shield has been
manufactured exclusively to protect against
drops and splashes during the COVID-19
emergency and is not intended for general use,
nor should it be used for any other purposes.
USE LIMITATIONS:
The PPE does not protect against aerosols or
suspended particles.
For greater protection it is advisable to use it in
conjunction with a protective mask.
ASSEMBLY INSTRUCTIONS,
SUITABLE ACCESSORIES AND
REPLACEMENT PARTS. (FIG. 1)
To adjust the face shield, proceed as follows:
8.
Take the materials out of the envelope.
9.
Remove the protective film stuck to
both parts of the visor.
10. Fit the visor by positioning the longest
side horizontally between strips A and
B.
11. Insert the end of the elastic strap into
hole 2 on the support, making it
protrude by some 5 cm.
12. Expand the wings to fasten the visor.
13. Insert the end of the elastic strap into
hole 1 on the support to fasten it.
14. Place on head and adjust the elastic
strap.
EN