nurse tour Manual De Instrucciones página 11

GB
OPENING THE PUSHCHAIR
1.1
Release the plastic catch on the handle.
1.2 Hold the handles and lower the front wheels towards the ground.
Do not try to open to the chair by forcing the handles.
1.3
Step on the locking hinge to open the pushchair.
ASSEMBLING THE FRONT WHEELS
Press down on the tab, located in the lower part between the two wheels, and insert it in the
2
end of the pram structure, until you hear the click as it locks into position.
ASSEMBLING THE HOOD
3.1 Put the ends of the ratchets into the slots on the side bar, then move the velcro around the bar
and attach it to the hood.
To open the hood, pull forward and press the side hinges of the hood.
3.2
To close the hood, pull the hinges at the sides and push backwards.
WARNING: The hood must always be completely closed before folding the pushchair.
USING THE FRONT SWIVEL WHEEL
4.1
Press the locking clip downwards to allow the wheel to swivel.
4.2 To lock the wheel, pull the locking clip upwards.
APPLYING THE BRAKES
5.1
To engage the brakes, press down on the brake pedal with the foot.
5.2 To release the brakes, push the brake pedal up with your foot.
WARNING: Always apply the brakes when the pushchair is stationary.
SAFETY HARNESS
6
Adjust the harness each time a child is in the pram.
- Your BOULEVARD is equipped with a 5-point harness.
- Put the child in the seat and place the strap (1) between its legs.
- Position the strap (2) over the shoulders of the child, then push the clips (3) into the buckle (4).
You will hear a click when the harness is attached properly.
- Adjust the length of the
PARA AJUSTAR EL RESPALDO
This pushchair has an adjustable backrest. The raised position of the backrest should not be used
7.1
for children of less than six months.
Press both left and right bars and pull towards the rear of the pram, until the appropriate rest
position has been reached.
7.2
Raise the backrest to a more upright position.
WARNING: Do not adjust the backrest while the child is in the pushchair.
ADJUSTING THE BACKREST
8
Simultaneously press the buttons located at the sides of the footrest and adjust to the appropriate
position.
FOLDING THE PUSHCHAIR
9 Lift up the locking hinge. Press down on the secondary safety lock, then push forwards.
Close the catch (1.1).
10
Rain cover.
TO ASSEMBLE/DISASSEMBLE FRONT BUMPER ASSEMBLE:
11
Align front bumper pegs with the holes on bumper
adaptors. Slide and press into until hear clicks. Disassemble: Press down both side buttons
to disassemble bumper from adaptors.
IM 1821 ,00 TOUR.indd 11
INSTRUCCIONES
11
26/02/15 10:41