Tabla de contenido
Publicidad
GB - English
Technical specifications
• Power lamp:
2x 24 W (48 W)
• Colour temperature: 5200 - 5600 K daylight
• Dimensions:
470 x 470 x 530 mm
Safety precautions
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician when service is required. Disconnect the product from mains
and other equipment if a problem should occur. Do not expose the product to water
or moisture.
User instructions
Photo 1
1. Open the four reflecting boards, and then open the background board from under the reflecting board.
See Photo 1.
2. Attach the background to the background board and bottom reflecting board using the small clamp.
3. Close the top reflecting board onto the background board using the small clamp. See Photo 2.
4. Put the object to be shot onto the background, switch on the 230 V power, turn on the lamps for 3 to
5 minutes, then you can start taking the pictures.
5. Set the white balance of DC to "A" or "
background, please use the ISO200 f/8 1/60 exposure value for test shooting, to choose other colour
backgrounds, please increase the exposure value.
6. While shooting, if the effect of a top light to dim the project is needed, please raise the top reflecting
board slightly upwards; If the effect of left light to dim the project is needed, please open the left
reflecting board slightly. If the effect of right light to dim the project is needed, please open the right
reflecting board slightly.
7. When shooting is finished, please turn off the power. To store, please remove the background, close the
background board, then close the bottom and top reflecting boards, and finally close the left and right
reflecting boards.
8. To change lamps, please turn off the power, remove the transparent protective cover by loosening the
bolts, pull out the broken lamp and insert a new lamp, then put the protective cover back.
Maintenance
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
©2012 NEDIS BV. Camlink is a registered trademark of NEDIS BV. Although every effort has been made to ensure
the accuracy of the information contained in this manual specifications are subject to change and therefore
NEDIS BV cannot guarantee its correctness and completeness at all times.
Photo 2
" or "K" or "PRE
". To take photos with white colour
3
Publicidad
Tabla de contenido
