Smith Performance Sprayers S103EX Manual De Uso Y Cuidado página 4

Filling
IMPORTANT: Always make sure the pressure is
released from the tank before fi lling or servicing.
1. Pull up on the knob of the pressure release
valve until all the pressure is released from the
tank. (See Figure F.)
Pump Unlocking And Pressurizing
ZL Shut-off Spraying and Locking
1. Direct nozzle away from you and squeeze shut-off
lever to begin spraying.
2. For continuous spraying, squeeze lever and rotate
lock up. (See Figure G).
3. Unlock if needed and release shut-off lever to stop
spraying. (See Figure H)
4. Turn the nozzle tip to adjust the spray pattern.
OPERATING INSTRUCTIONS
Pump Clamp Tab
TO UNLOCK PUMP: Turn handle counterclockwise until
4-prong clamp is loose, then rotate clamp counterclockwise
aligning the tabs with the slots in the neck of the tank and
remove the pump.
TO LOCK PUMP: Align clamp tabs with the slots in the neck
of the tank and lower the pump assembly, rotate the 4-tab
clamp clockwise to the stop position and rotate the handle
clockwise to tighten, seal and lock the tank cover.
TO PRESSURIZE: Push down on the handle to depress coil
spring and turn handle 1/4 turn counterclockwise to unlock
handle. Pressurize the sprayer by pumping the handle in a
smooth up and down motion. Push down on the handle
to depress coil spring and turn handle 1/4 turn clockwise,
then allow handle to raise into lock position.
Figure G
Figure H
Figure F
Page 4