Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LATCHING HOSE
The hose reel system has been equipped with a
continuous click-lock mechanism. Pull the air hose to
the desired length and release. The reel will automati-
cally lock to the desired position when released.
REWINDING HOSE
Give the hose a short, sharp pull to release the
locking mechanism and rewind the hose. To retract
the hose safely, hold onto the hose and slowly allow it
to rewind onto the reel.
WARNING:
Do not let go of the hose until fully
retracted. Allowing the hose to retract
uncontrolled may result in serious
injury.
HOSE STOPPER ADJUSTMENT
To permanently store the hose outside the reel, pull
the hose out to the desired position and latch. Loosen
the hose stopper screws, slide the stopper to the reel
opening, and tighten screws to secure.
08
HTTP://WWW.FREEMANTOOLS.COM
WARNING:
Ensure the hose is completely latched in
position before loosening the hose
stopper.
MAINTENANCE
Detach air supply from the product before perform-
ing any inspection, maintenance, or cleaning
procedures.
Always keep the hose clean after use.
Do not allow tools to hang on the end of the hose
when not in use.
Do not allow the hose to come in contact with hot
or sharp surfaces, which may damage the hose.
Always rewind the hose back into the reel when
work is completed.
1-888-669-5672
PARTS LIST AND DIAGRAM
1.
Left Label Cover
2.
Inlet Hose Connector
3.
Left Case
4.
Belt
5.
Guide
6.
Air Hose
7.
Drum Wheel
8.
Ratchet Plate
9.
Ratchet Lock Assembly
10.
Center Shaft
11.
Drum Wheel Inner Cap
12.
Spring
13.
Spring Housing Outer Cover
14.
Tension Cover
15.
Right Label Cover
16.
Plastic Pivot
17.
Mounting Bracket
HTTP://WWW.FREEMANTOOLS.COM
09
1-888-669-5672
Publicidad
Capítulos
Tabla de contenido
