VI. OPERATING THE DEVICE
EN
Before initial start of the device, please make sure
that the water heater has been correctly connected
to the electrical network and that it is filled up with
water.
Switching on the water heater is done through
the device incorporated in the installation, which
is described in sub-item 3.2 of paragraph V, or
by inserting the plug into an electrical socket (for
models with cord with a plug).
Clarification to Fig.5:
1 - Light indicator
2 - Regulator handle
Lamp (1) is on when the boiler is switched on in
water heating mode. Lamp (1) switches off when
the water reaches the preset temperature and
indicates that the appliance is not in operation.
Temperature setup
This setup allows the gradual setting of the desired
temperature, achieved by using a handle on the
control panel.
Protection according to the temperature.
The appliance is equipped with a special facility
(thermal circuit-breaker) for protection against
over-heating of the water, which is switching off
the heater from the electricity network, when the
temperature reaches too high values.
When this device operates, it does not
self-reset and the appliance will not work.
Please call an authorized service for solving the
problem.
VII. RUST PROTECTION MAGNESIUM
ANODE
The magnesium anode protects the water tank's
inner surface from corrosion. The anode element
is an element undergoing wear and tear and is
subject to periodic replacement.
In view of the long-term and accident free use of
your water heater, the manufacturer recommends
periodic inspections of the magnesium anode's
condition by a qualified technician and replacement
whenever required, and this could be performed
during the appliance's technical preventive
maintenance.
For replacements, please contact the authorized
service stations!
VIII. PERIODIC MAINTENANCE
Under normal use of the heater, under the influence
of high temperature, lime scale /the so-called lime
scale layer/ is deposited upon the heating element's
surface. This worsens the heat exchange between
the heating element and water. The heating
6
Instructions for use and maintenance
element's surface temperature increases along /of
boiling water/. The thermoregulator begins to switch
on and off more frequently. A ''deceptive" activation
of the thermal protection is possible. Due to these
facts, the manufacturer recommends preventive
maintenance of your water heater every two years
by an authorized service center or service base. This
protective maintenance must include cleaning and
inspection of the anode protector (for water heaters
with glass-ceramic coating), which shall be replace
with a new one if need arises. Each preventive
maintenance of the said type must be entered in the
appliance's warranty card and must outline date of
performing the preventive maintenance, company
performing the preventive maintenance, name of
person performing the preventive maintenance, and
signature.
Non-fulfillment of the above requirement may
terminate the free of charge maintenance of your
boiler. In order to clean the appliances use a damp
cloth. Do not clean with abrasive or solvent content
detergents. Do not pour water over the appliance.
The manufacturer does not bare the
responsibility for all consequences caused by
not obeying the instructions, given hereby.
DISPOSAL OF PACKAGING AND PRODUCT
Dispose
environmentally-friendly manner.
This appliance is labelled in accordance
with
European
EU concerning used electrical and
electronic appliances (waste electrical
and electronic equipment - WEEE). The
guideline determines the frame work for the return
and recycling of used appliances as applicable
throughout to the EU.
PACKAGE INFORMATION:
Packaging materials of the product are manufactured
from recyclable materials in accordance with
our National Environment Regulations. Do not
dispose of the packaging materials together with
the domestic or other wastes. Take them to the
packaging material collection points designated by
the local authorities
of
packaging
in
Directive
2012/19/
an