StetSom ALCANCE CONTROL Manual De Instrucciones página 9

2. Press any one of the TX4 transmitter's keys except for the 2nd/Power key (02).
3. The LED indicator (09) stops blinking. Synchronization is complete.
– To desynchronize all of the transmitters:
1. Press the SYNC button (10) on the RX4 receiver. The LED indicator (09) will flash.
2. Press the MEM key (11) on the RX4 receiver. The LED indicator (09) will blink faster
and turn off. All transmitters have been deleted.
– Restoring Factory Settings:
Hold the SYNC/RESET key (10) down for 5 seconds. The LED indicator (09) will flash
and the factory settings will be restored. The synchronization of the TX4 transmitters
will be maintained.
– Diagnosing a problem:
– Indications of a weak battery:
When the TX4 transmitter's key is released, the transmission indicator LED (01) and
the receiver's LED indicator (09) will remain on for 1 second. We recommend that you
replace the battery with a new one, model CR2032, since the transmitter's efficiency
will decrease.
The TX4 transmitter turns itself off if any key is pressed for more than 10 seconds to
avoid draining the battery. When you release the key, the system will return to normal.
– Changing the battery of the TX4 Transmitter:
Remove the Holster, loosen the two screws on the back and remove the circuit bo-
ard from its plastic housing. Replace the old battery with a new one being careful to
maintain the correct polarity; the Clip must be in contact with the POSITIVE terminal
of the battery.
– Loss of synchronization:
Loss of sync occurs when the TX4 transmitter's keys are pressed more than 250 times
when it is out of range of the TX4 receiver. In this case, the receiver fails to respond to
the TX4 transmitter's commands and its LED indicator (09) blinks permanently. Re-syn-
chronize the transmitter with the receiver to restore operation.
– Techinical Specifications:
Power Source:
Receiver: 5 a 16V DC
Transmitter: CR2032 Battery (3V)
Maximum Current Consumption:
Receiver: 30mA
Transmitter: 15mA
Dimensions:
Receiver: 10,0 x 25,0 x 55,0 mm
Transmitter: 16,5 x 39,0 x 74,0 mm
Weight:
Receiver: 39g
Transmitter: 27g