CREE LIGHTING CSC-CWD Manual De Instrucciones página 2

1
TOP
5NW1
On
Off
120-277VAC
60Hz XX
APPLIANCE
CONTROLS
3
NEUT
WALL CONTROLS FEATURES
• The Cree Wireless Dimmer supports on,
off, and dimming controls. See Figure 1.
• The Cree Wireless CCT Dimmer supports
on, off, and dimming, and color controls.
Color is adjusted up by simultaneously
pressing the On and Dimming up
buttons. Color is adjusted down by
simultaneously pressing the Off and
Dimming down buttons. See Figure 1.
• The Cree Wireless Switch supports on
and off, controls. See Figure 2.
2 of 3
CSC-CCD
Dimming
Up
LED
Dimming
Down
18AWG Cu wire
Made
in China
GND
LINE
SUPPLY
LEADS
INSTALLATION
NOTE: For ease of installation, Cree
recommends using a deep wall box.
STEP 1:
Disconnect power to circuit by turning circuit
breaker OFF before installation.
STEP 2:
If necessary remove existing wall plate and
switch.
STEP 3:
Strip existing wires ½". If two wires will be
connected to the same terminal on the Cree
device, both wires must be the same gauge
(12AWG or 14AWG).
STEP 4:
Wire the LINE (black), NEUTRAL (white),
and GND (green or bare) supply wires to the
corresponding pigtail leads on the Cree device,
as shown in Figure 3.
For wireless dimmers with no neutral wire.
Wire the LINE IN (black) to supply wires, LINE
2
TOP
5NW1
On
Off
120-277VAC
60Hz XX
APPLIANCE
CONTROLS
4
LINE
LINE IN
OUT to the switched power, and GND (green or
bare) supply wires to the corresponding pigtails
on the Cree device, as shown in Figure 4.
NOTE: If replacing an existing wall switch
with a wireless dimmer with neutral wire
connection, the wall dimmer shall be wired as
instructed; however, the switched power to the
load must also be tied directly to the AC supply
leads.
STEP 5:
Attach the wall plate (reference the wall plate
instruction sheet).
STEP 6:
Switch the circuit breaker ON.
STEP 7:
Press and release the OFF paddle. The blue
LED should blink twice and then go off. If the
blue LED does not respond with the two-blink
sequence, please follow the RESET instructions
to return the wall control to factory defaults.
CSC-CWS
LED
18AWG Cu wire
Made
in China
GND
LINE TO
LOAD
SUPPLY
LEADS
LPN00838X0001A0_A