How To Hang And Wire Your Ceiling Fan - Fanimation The Brewmaster FP10 Serie El Manual Del Propietario

Ocultar thumbs Ver también para The Brewmaster FP10 Serie:

Manual de instrucciones (36 páginas)

Tabla de contenido

Idiomas disponibles

INSTALLATION NOTE

It is recommended that each fan and the motor have ¾˝

plywood backing secured to a structural member for

adequate support (Figure 1). The motor unit will not

operate more than 4 pulley/blade assemblies.

▲WARNING

Do not install or use fan if any part is damaged or

missing. This product is designed to use only those

parts supplied with this product and/or any accessories

designated specifically for use with this product by

Fanimation. Substitution of parts or accessories not

designated for use with this product by Fanimation could

result in personal injury or property damage. Contact

your retail store for missing or damaged parts.

INSTALLATION NOTE

Motor assembly can be mounted at either end of Pulley

assembly or in the middle.

1. You will first drill 3/16˝ pilot holes into the plywood base

or supporting member to prevent splitting or cracking.

Mount the Pulley Assembly on the ceiling with 4 lag bolts

and flat washers (Figure 1a).

2. Drill 3/16˝ pilot hole located approximately as shown

in Figure 1a & 1b for lag "J" hook. Screw lag hook into

ceiling.

3. Hang motor assembly on lag hook for ease of wiring

fan motor (Figure 1b).

INSTALLATION NOTE

The fan must be hung with at least 7' of clearance from

floor to blade. The maximum overall (belt) length between

motor & pulley is 14´ and the minimum is 4´. (Figure 2)

For two-pulley assembly installation: The maximum

overall distance between two pulley assemblies is 13½´

and the minimum is 5´.

CAUTION

Do not connect fan blades until the fan is completely

installed. Hanging fan with blades connected may result

in damage to the fan blades.