TooQ PRODATA Serie Manual De Usuario página 18

EN
During the CLONE process, those LED indicators will flash
to show the percentage of the progress:
Begin clone process: for LEDS flashing one be one LED
Green LED stays solid: 25%
Red LED stays solid: 50%
Yellow LED stays solid: 75%
Orange LED stays solid: 100%
7. When the process of the clonation is finished. please
press the power button to turn off the docking station.
Please take out those hard drives carefully because they
may be very hot.
These are normal:
1. Those hard drives may become hot during clonation
process.
2. The clonation process may take various hours to finish.
3. Those hard drives may produce noise during the
clonation process.
4. A cloned drive also takes over the disk ID from the
master drive. This causes Windows Vista, Win7/ 8/ 10 to
shut down one of the drives
if both drives are placed into the HOD docking after
cloning. The disk can be switched "online" again in the
windows option "Disk Management".
18
Device Mode
The device mode permits the docking station to act as
external dual hard drives that allows you to backup the
data of your computer to those external hard drives.
1. Make sure that those hard drives have no bad sectors.
Bad sectors will cause unpredictable problems.
2. Put one or two hard drives into the docking station.
Please make sure that those hard drives are correctly
and firmly connected to those SATA connectors of the
docking station.
3. Connect the USB cable to the docking station and to a PC.
4. Connect the power adapter to the docking station and
to a main.
5. Power up the docking station by pressing the power
switch.
Now, the computer should detect the new hardware.
In Windows XP or later it is not necessary to install driver.
If windows can't recognize the docking station, please refer
to the FAQ for more information.