LEXIBOOK DMPJ1 Manual De Instrucciones página 15

• If you hear interference noise during playback when using
headphones or if the eyebrows stop their movement when the
buttons are pressed, it means the batteries are running low.
Replace the batteries regularly.
AC operation
1. Check that the unit is switched off.
2. Insert the small end of the AC cord (not included) into the AC
socket at the back of the unit.
3. Plug the other end of the AC cord into any convenient
AC 230V – 50Hz power outlet.
Note: the socket-outlet shall be installed near the equipment and
shall be easily accessible.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the product
before being charged. Rechargeable batteries are only to be
charged under adult supervision. Different types of batteries or
new and used batteries are not to be mixed. Only batteries of
the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity. Exhausted
batteries are to be removed from the product. The supply
terminals are not to be short circuited. Do not throw batteries
into a fire. Remove the batteries if you are not going to use the
product for a long period of time.
WARNING: Mal-function or loss of memory may be caused by
strong frequency interference or electrostatic discharge. Should any
abnormal function occur, reset the unit or remove the batteries and
insert them again, or unplug the AC/DC adapter from the mains
socket and replug it again.
INSTALLING THE LIGHTSTARMP3 SOFTWARE
Follow these instructions to install the LightStarMP3 program on
your PC system.
1. Insert the CD Software (included) in your CD-ROM drive.
2. Click "Start", then "My Computer" and double-click your CD-ROM
drive.
3. Double-click the "Setup.exe" file to launch the installation.
4. Select the installation program language and click the "Ok" key.
5. Follow the instructions to install the LightStarMP3 software.
6. Once the software has been installed, click "Finish".
Note: Make sure the DMPJ1 is not connected to your computer
before installing the software.
15