Publicidad
FORCE
TM
TIRE AIR PRESSURE
Check at regular intervals and maintain.
Rear Tires - 20 Psi (137 kPa).
TROUBLESHOOTING
Problem
Abnormal vibration
Engine will not start
Engine is locked, will not pull
over
TM
Aim-N-Shoot
lever sticking
*Using compressed air, or a backpack blower, you can
loosen or free debris easily from the impeller and housing,
which can cause wear and tear on the machine. You can
manually remove debris by taking off the front housing.
NOTE: Always disconnect the spark plug when servicing.
(See Fig. 4 and 5)
Part No 441247
601V BLOWER Owner's Manual
Possible Cause
Loose or out of balance impeller.
Debris in impeller.
Loose engine.
Engine not in full choke position.
Out of gasoline or bad, old gasoline. Check gasoline.
Spark plug wire disconnected.
Gas valve off.
Dirty air cleaner.
Engine problem.
Debris stuck around cone.
Cone adjustment knob too tight.
Adaptor mount nut (item #43) too
tight.
Check impeller and replace if required.
Clear debris with compressed air or a
backpack blower (See Fig . 4 and 5 below).*
Check engine.
Check choke position.
Connect spark plug wire.
Turn on gas valve.
Clean or replace air cleaner. Contact a
qualified service person.
Contact an engine servicing dealer for
engine problems.
Clean debis.
Apply silicone based lubricant to
pivot points.
Loosen manual adjustment knob.
Loosen nut.
Fig. 4
7
Solution
Fig. 5
441247_B_LO
Publicidad
