Tabla de contenido
Publicidad
FORCE
TM
TIRE AIR PRESSURE
Check at regular intervals and maintain.
Rear Tires - 20 Psi (137 kPa).
TROUBLESHOOTING
Problem
Abnormal vibration
Engine will not start
Engine is locked, will not pull over Engine problem.
TM
Aim-N-Shoot
lever sticking
*Using compressed air, or a backpack blower, you can
loosen or free debris easily from the impeller and housing,
which can cause wear and tear on the machine. You can
manually remove debris by taking off the front housing.
NOTE: Always disconnect the spark plug when servicing.
(See Fig. 4 and 5)
Part No 441242
6 BLOWER Owner's Manual
Possible Cause
Loose or out of balance impeller.
Debris in impeller.
Loose engine.
Engine not in full choke position.
Out of gasoline or bad, old gasoline.
Spark plug wire disconnected.
Gas valve off.
Dirty air cleaner.
Debris stuck around cone.
Cone adjustment knob too tight.
Adaptor mount nut (item #43) too
tight.
Check impeller and replace if required.
Clear debris with compressed air or a
backpack blower (See Fig . 4 and 5 below).*
Check engine.
Check choke position.
Check gasoline.
Connect spark plug wire.
Turn on gas valve.
Clean or replace air cleaner. Contact a
qualified service person.
Contact an engine servicing dealer for engine
problems.
Clean debis.
Apply silicone based lubricant to
pivot points.
Loosen manual adjustment knob.
Loosen nut.
Fig. 4
8
Solution
Fig. 5
Form No F110215C
Publicidad
Tabla de contenido
