Automated Learning Process./Activating Code; Wall Control Operation - Ellington AVL56BNK5RW Guia De Instalacion

10. Automated Learning Process./Activating Code.

CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the
transmitter. Use the same number sequence used
when wiring the wall control in Section 6.
NOTE: Since this fan does not come with a light
kit, set the dimmer switch (labeled "D" and "X") in
the "OFF" position (X).
Install one 9-volt battery (sold separately) in
transmitter. Note: Leave battery connected but
outside of battery compartment until learning
process is complete.
Restore electrical power and then set slider
switch on wall control to the ON position. Within
30 seconds of turning on the wall control, press
the "OFF" button, located on the front of the
transmitter, for 5 seconds. Test the fan functions
to confirm the learning process is complete--see
Section 13.
Place battery in battery compartment and then
re-attach battery cover on transmitter.

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
REV button - used to REVERSE blade direction (fan
must be set on low before reversing blade
direction)
LIGHT button - (for use with optional light kit,
sold separately) turns light ON/OFF when pressed
once; dims light when pressed and held down
TRANSMITTER
dimmer
switch
TRANSMITTER
page 8
code
(back)
switches
battery
cover
(front)