Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ER 1200K – cod. 52629
✓ Set the correct distance adjusting the parallel stop, then fix it with the setting screws
✓ Switch on the router
✓ Lower the machine slowly until when the cutter touch the workpiece and then perform the
routing job
6.c Use of a Template
This tool is also supplied with a template tool , which screws onto the
bottom of the baseplate in place of the vacuum dust extraction assembly.
A template can be used to engrave a design on a surface. You need to
cut a template from a sheet material such as plywood or sheet metal at
least 3mm thick. The template is then clamped to the workpiece (see
sketch below) and the template tool allows you to follow the edge of the design. The template
tool can be used with cutter bits with a diameter of less than 13mm.
7. MAINTENANCE
Keep cleaned the ventilation
using air compressed.
8. WARRANTY
This power tool is guaranteed for a period of 24 months, from possible defects of manufacturing.
Warranty shall cover regular operation of product and won't include defects caused by wear,
improper maintenance, tampering by unskilled people, improper usage, usage of improper
accessories, overloading condition etc. Warranty shall remain valid if the purchasing date shall be
confirmed by bill of lading, invoice, ticket as evidence.
Information on disposal for users of waste electrical & electronic equipment.
9.
This symbol on the products and/or accompanying documents means that used
electrical and electronic products should not be mixed with general household
waste. For proper treatment, recovery and recycling, please take these products to
designated collection points, where they will be accepted on a free of charge basis.
Disposing of these products correctly will help to save valuable resources and prevent
any potential negative effects on human health and the environment which could
otherwise arise from inappropriate waste handling. Please contact your local
authority
for
further
details
of
your
nearest
designated
slits in the motor housing
collection
point.
16
Publicidad
Tabla de contenido
