Braun cruZer 3 Z50 Manual Del Usuario página 12

Using the trimming attachments (7) and (10)
• The trimming attachment (7) is ideal for beard trimming
and keeping it at a constant length.
• Place the trimming attachment onto the shaver foil (2) and
press it against the shaver housing until it snaps into place
with a click.
• Press the beard length selector (8) (e) and slide it up in
order to set the desired beard length (length settings from
top to bottom 1.2 mm, 2.8 mm, 4.4 mm, 6 mm). Push up
the styler (4).
• Activate the on/off switch and trim against hair growth by
guiding the transparent comb part over the skin.
• The short beard attachment (10) is perfectly suited for
creating a stubble look and maintaining it. Attach the
short beard attachment the same way as the trimming
attachment (7). Push up the styler and use the appliance
as shown (f). The short beard attachment ensures an
optimum usage angle.
Cleaning
This appliance is suitable for cleaning under an open
water tap. Warning: Detach the hand-held part from
the power supply before cleaning it in water.
Regular cleaning ensures better shaving performance.
Rinsing the shaving head after each shave under running
water is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaving head
under hot running water (g). A natural based soap may
also be used provided it contains no particles or abrasive
substances. Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, remove the shaver foil and the
cutter block. Then leave the disassembled shaving parts
to dry.
• If you regularly clean the shaver under water, then once a
week apply a drop of light machine oil onto the long hair
trimmer and shaver foil (i).
Alternatively, you may clean the shaver using the brush
provided (h):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area
of the shaver head. However, do not clean the shaver foil
with the brush as this may damage the foil.
12