Yakima GEAR BOXES Manual De Instrucciones página 2

MEASURE THE DISTANCE BETWEEN THE CROSSBARS ON YOUR RACKS.
FOR BARS
THAT CAN'T MOVE:
(INCLUDING Q TOWERS)
Measure from bar to
bar to determine
which sets of holes
your box will use.
0" 0"
Long Boxes
ON THE OUTSIDE OF THE BOX:
• CARRIAGE BOLT:
Insert through curved bracket,
then through large plate.
;;;;
;;;;
• T-BOLT:
1032666B-2/8
DO NOT LOAD THE BOX ONTO THE CAR YET.
Q TOWER NOTE:
NEVER REPOSITION
THE TOWERS!
30"– 36" 33"– 36"
onto bolts.
;;; ; ; ;;;
Insert through large
plate only.
Curved bracket
should swing freely.
FOR BARS
THAT MOVE OR SLIDE:
Bars should be
positioned at 30" to
36" apart for Long
Boxes.
Position bars at 24"
to 36" apart for the
SpaceCadet only.
0" 0" 18"– 36" 24"– 36"
SpaceCadet
INSIDE OF BOX: ATTACH KNOBS:
Set metallic plate
Engage the threads of the bolts
;;;;
with one slight turn—no more.
The knobs must be very loose.
TIGHTEN YOUR
CROSSBARS IF YOU
LOOSENED THEM.
Do not drill
additional
holes.
LOAD BOX ONTO
RACKS.
Curved brackets should swing
freely.
Be sure the brackets are not
interfering when box is
positioned on the bars.
A friend could help
INSIDE
THE BOX:
Push plugs into
unused holes.
Attach adhesive pads
to metallic plates.
with this part.