LiftMaster MyQ 889LM Manual De Instrucciones página 4

ERASE DEVICES FROM MEMORY
Erase all remote controls and keyless entries:
1. Press and hold the LEARN button on the control panel until the red learn
LED goes out (approximately 6 seconds). All remote control and keyless
entry codes are now erased. Reprogram any compatible accessory you wish
to use.
NOTE: Erasing remote controls and keyless entries from the control panel does not erase
them from the garage door opener, you need to erase the memory of the garage door opener
separately.
Erase all devices (including MyQ enabled accessories):
1. Press and hold the LEARN button on the control panel until the red learn
LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the red learn LED
goes out. All codes are now erased. Reprogram any compatible accessory
you wish to use.
TROUBLESHOOTING
• If the yellow command LED does not turn on, reverse the wires connected
to the R and W terminals of the control panel. Replace wire if necessary.
• If yellow and red LEDs are blinking slowly, the control panel is not
compatible with your garage door opener.
• If the yellow and red LEDs are blinking quickly, the control panel is
charging, and may take up to 5 minutes to become operational.
WARRANTY
FIVE YEAR LIMITED WARRANTY
LiftMaster warrants to the first consumer purchaser of this product that is free
from defect in materials and/or workmanship for a period of 5 years from the date
of purchase.
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada's license-exempt RSSs.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device must be installed to ensure a minimum 20 cm (8 in.) distance is maintained between users/
bystanders and device.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC rules and Industry Canada ICES standard. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4
1-800-528-9131
LiftMaster.com