QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
1. Pump is preset to 230V. If your power source is 115V
you will need to change pump from 230V to 115V.
Open the back of the motor housing. Use pliers to
switch plugs following the steps below for your model.
MODEL 025191
STEP 1: Move blue wire
from slot 2 to slot 1
STEP 2: Move brown
wire from position 6 to
slot 2
MODEL 148014
STEP 1: Move blue wire
from slot 2 to slot 1
STEP 2: Move brown
wire from slot 3 to slot 2
Brown
2. Install pump on a firm, level base or pad with screws
or bolts. The base MUST be solid, level, rigid, vibration
free and protected from both weather and pool splash.
• Make sure pump inlet height is as close to the water level as possible.
3.Using short,
direct suction
pipe, connect
the skimmer/pool
drain to pump
inlet.
POOL PUMP
MODEL 148014, 025191
(LINE)
(LINE)
Black
Black
(LINE)
(LINE)
White
White
4
5
7
Blue
Brown
Blue
Brown
(LINE)
(LINE)
Black
Black
(LINE)
(LINE)
White
White
4
5
7
Blue
Blue
Brown
Pump inlet
Pipe Union
Pool
Skimmer
WARNING:
ALWAYS DISCONNECT PUMP FROM
POWER SOURCE BEFORE HANDLING.
4. Attach discharge
line from pump to
filter inlet and attach
shut-off valve.
• Suction line pipe must
be the same diameter or
larger than the discharge
line.
5. Connect return
line from filter to
swimming pool
4
return inlet.
5
7
4
5
7
6. Make sure power is
off and attach wiring.
WARNING:
disconnect pump
from electricity before
performing any work
on the motor. Refer to
instructions for wiring
connections.
7. Fill pump and trap with
water, replace trap lid and
check system for leaks.
If no leaks, proceed with
Shut Off
Valve
pump startup. DO NOT
START PUMP if any
Pump
Inlet Pipe
leaks are present in the
system.
8. Turn pump power on and check for leaks again at
IL2562
IL2562
each connection.
FOR YOUR PROTECTION,
SEE INSTRUCTION MANUAL FOR
IMPORTANT SAFETY WARNINGS.
Pump Discharge Line
Pipe Union
Always
Shut Off
Valve
Filter Inlet
Return Line
IL2562
Filter Outlet
Return Line
Goes to Pool Jets
IL2562
Fuse Box
Fuse Box
Fill Level
SW1608 B