CDA EVC4 Manual De Utilización página 22

saturation level depends on the frequency with which
the appliance is used, the type of cooking performed
and the regularity with which the anti-grease filters
are cleaned.
• Remove build-up from the fan and other surfaces of
the cooker hood regularly using a cloth moistened
with denatured alcohol or non-abrasive neutral liquid
detergent.
• The light on the cooker hood is designed for use
during cooking and not for general room illumination.
Extended use of the light reduces the average
duration of the bulb.
• Replacing halogen light bulbs (Fig. 15).
To replace the halogen lamps B, from the inside of
the cooker hood press downwards with two fingers
as shown in Fig. 15.
Replace the bulbs with new ones of the same type.
• COMMANDS: (Fig.16) LUMINOUS the key symbols
are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
• If your appliance does not have the INTENSIVE
speed function, press key E for two seconds and it
will be activated for 10 minutes after which it will return
to the previously set speed.
When the function is active the LED flashes. To in-
terrupt it before the 10 minutes have expired press
key E again.
• By pressing key F for two seconds (with the hood
switched off) the "clean air" function is activated. This
function switches the appliance on for ten minutes
every hour at the first speed. As soon as this function
is activated the motor starts up at the first speed for
ten minutes, During this time key F and key C must
flash at the same time.
After ten minutes the motor switches off and the LED
of key F remains switched on with a fixed light until
the motor starts up again at the first speed after fifty
minutes and keys F and C start to flash again for ten
minutes and so on.
By pressing any key for the exclusion of the hood
light the hood will return immediately to its normal
functioning (e.g. if key D is pressed the "clean air"
function is deactivated and the motor moves to the
2nd speed straight away. By pressing key B the
function is deactivated).
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds,
the grease filters must be cleaned.
- When button A flashes at a frequency of 0.5
seconds, the carbon filters must be replaced.
All manuals and user guides at all-guides.com
- 22 -
After the clean filter has been replaced, the electronic
memory must be reset by pressing button A for
approximately 5 seconds, until the light on the button
stops flashing.
THE MANUFACTURER
RESPONSIBILITY FOR EVENTUAL DAMAGES
CAUSED BY BREACHING
WARNINGS.
DECLINES ALL
THE ABOVE