Retekess F9501D Manual Del Usuario página 8

To add a card and PIN user in card and PIN mode (
To Add a card and PIN user
(The PIN is any four digits between 0000
& 9999 with the exception of 1234 which
is reserved.)
To change a PIN in card and PIN mode
(Method 1) Note that this is done outside
programming mode so the user can
undertake this themselves
To change a PIN in card and PIN mode
(Method 2) Note that this is done outside
programming mode so the user can
undertake this themselves
To delete a Card and PIN user just delete
the card
To add a card user in card mode (
To Add and Delete a card user
To delete All users
To delete ALL users. Note that this is a
dangerous option so use with care
To unlock the door
For a PIN user
For a card User
For a card and PIN user
2. Door Settings
Relay Output Delay Time
To set door relay strike time
Normal status: No keypad lockout or
alarm (factory default)
Keypad Lockout
3
Add the card as for a card user
Press
*
Then allocate the card a PIN as follows:
Read card 1234 # PIN # PIN #
*
Read Card
*
New PIN #
ID number #
*
New PIN #
2 User ID
)
3 0 #
The operating is the same as adding and deleting a
card user in
2 0000
Enter the PIN
Read card
Read card then enter PIN #
Master code #
*
0-99 is to set the door relay time 0-99 seconds
7 0 # (Factory default setting)
7 1 #
6
)
1 #
to exit from the programming mode
Old PIN #
Old PIN #
#
3 2 #
#
then press #
4 0～99
New PIN #
New PIN #
# *