Hanging The Fan - Progress Lighting AirPro P2572 Manual De Instalación

Hanging the Fan

REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE: For better fan performance, make
sure the mounting plate is level. Additional
washers (not included) may be needed
to insert between the outlet box and the
mounting plate.
1. Securely attach the mounting plate to the
outlet box using the two screws supplied
with the outlet box. Pull the 120-volt
supply wires (the black, white and ground
wires) out of the outlet box and through
the hole in the mounting plate and lay
them to the side. (Figure 4)
2. Carefully lift the fan-motor assembly and
engage the slot in the motor bracket on
the top of the fan-motor assembly with
the hook on the mounting plate so that it
is securely suspended. (Figure 5)
3. Connect the wiring to your fan according
to "6. Making the electrical connection".
4. Once the wiring is completed, proceed the
fan installation.
5. Remove two of the four screws (located
diagonally from each other) from the top of
the mounting plate and loosen the other two
screws.
6. Align the two key slots in the top of the
motor housing with the two loosened screws
on the mounting plate. Push the motor
housing up and turn it clockwise to lock in
the mounting plate. Tighten the two screws.
7. Install the two screws that were removed
in step 5 into the remaining two holes and
tighten the four screws firmly.
Screws (2)
KEEP THE HOOK ON THE MOUNTING PLATE
AWAY FROM THE PRE-INSTALLED RECEIVER.
TURN THE MOUNTING PLATE 180° WHEN
THE MOUNTING PLATE TOUCHES THE PRE-
INSTALLED RECEIVER.
Figure 4
Mounting Plate
Figure 5
Screws (4 )
Figure 6
4.