Charging The Battery; Pre-Ride Checklist - Kobalt Razor 2492277 El Manual Del Propietario

CHARGING THE BATTERY

Your electric scooter may not have a fully charged battery; therefore, you must charge the battery prior
to use. Be sure to charge the battery in a clean, dry location away from direct sunlight, flames or sparks.
• Initial charge time: 85 minutes.
• Recharge time: up to 85 minutes.
• Always charge the battery immediately after riding.
• Make sure the power is turned OFF when electric
scooter is not in use. If the ON/OFF switch is left on for
an extended period of time, the battery may reach a
stage at which it will no longer hold a charge.
Green LED
Charge Indicator
Red LED
Charge Indicator
Kobalt 24V Max Charger
Note: Charger design may vary from
one shown

PRE-RIDE CHECKLIST

Brake
Check the brake for proper function. When you squeeze
the brake lever, the brake should provide positive braking
action. When you apply the brake with the throttle on/
engaged, the brake cut-off switch should cut power to
the motor.
Wheels
Periodically inspect the wheels for excessive wear.
Tire
Periodically inspect the tire for excess wear and replace as
needed. Regularly check the tire pressure and inflate
as needed.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken
frames are rare, it is possible for an aggressive rider to run
into a curb or object and wreck, bend or break a frame. Get
in the habit of inspecting your scooter on a regular basis.
Kobalt_LowesSMU_US_MAN_200812.indd 6 Kobalt_LowesSMU_US_MAN_200812.indd 6
• Run time: Up to 30 minutes of continuous ride time.
Run time may vary depending on riding conditions,
rider weight, climate, and/or proper maintenance.
• Constant starting and stopping may shorten ride time.
• Battery life can vary depending on proper maintenance
and usage of the product.
• Do not charge at or below 32°F (0°C).
LED Light
For battery charging information, please refer to Kobalt 24V Max battery
manual and Kobalt 24V Max charger manual included with your electric
scooter or call 1-888-3KOBALT (1-888-356-2258).
Hardware/Loose Parts
Before every ride, check all parts, such as nuts, bolts, fasteners,
etc., to ensure they are secure and assembled correctly. There
should not be any unusual rattles or sounds from loose parts
or broken components. If the product is damaged, do not ride.
Reference "Safety Warnings" on pages 1 and 2 of
this manual.
Safety Gear
Always wear proper protective gear, such as an approved
safety helmet. Elbow pads and kneepads are recommended.
Always wear athletic shoes (lace-up shoes with rubber
soles) and keep shoelaces tied and out of the way of the
wheels, motor and drive system. NEVER RIDE BAREFOOTED
OR IN SANDALS.
Laws and Regulations
Always check and obey any local laws or regulations.
Insurance
Do not assume that your existing insurance policies necessarily
provide coverage for product use. Check with your insurance
company for information regarding insurance.
6 6
WARNING: Use ONLY
with the Kobalt 24V Max charger.
Batteries are only to be charged
under adult supervision. The charger
is not a toy. Always disconnect the
charger before wiping down and/or
cleaning the electric scooter with a
damp cloth.
The Kobalt 24V Max charger
supplied with the electric scooter
should be regularly examined for
damage to the cord, plug, enclosure
and other parts. In the event of such
damage, the electric scooter must
not be charged until it has been
repaired or replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Note: If the charger gets warm
during regular use, this is a normal
response and is no cause for
concern. If your charger does not get
warm during use, it does not mean
that it is not working properly.
WARNING: Battery charge
can deplete over time. Periodically
recharge battery when not in use.
8/12/20 1:10 PM 8/12/20 1:10 PM