Kathrein UFOcompact plus UFG 810 Manual Del Usario página 14

Installation steps
1. Fit the module carrier and connect potential equalisation to the regulations
(DIN EN 60728-11 and DIN EN 60065).
2. Sat-IF cables/drop cables (H and V) can be prepared/parked in the bottom section.
The bottom plate can be removed to insert or install cables.
3. Connect 230 V power cable (can also be lead/laid) in the bottom section.
Start-up
1. Install the system as described under "Installation procedure"
2. Insert UFOcompact plus
also be built in. To do so, one UFZ 800 (Order no. 20610124) channel unit adapter is
required per UFOcompact
3. Sat-IF drop cables (H and V) can be inserted directly into the modules (F-type connec-
tor) or through a matrix. All UFOcompact plus
4. Insert RF connector cable(s) (F-Quick) between the output socket(s) of the module
(F-type connector) and the output coupler in the head piece of the module carrier.
Unused RF female connectors are to be fi tted with terminating resistors.
5. Connect system to network
6. The UFOcompact plus
over a management interface of the UFX 800 central control module. This can be done
on site with a laptop or over remote conrol via TCP/IP using the management software
USW 800 (download available free of charge from "www.kathrein.de")
7. If the power supply system does not maintain the specifi ed permissible voltage values
(230 V~ ± 10%), we recommend using an uninterrupted power supply unit that com-
pensates this weakness of the electricity network.
Operation
Control of the channel unit is done over the control module UFX 800, the control interface
for all modules and channel units installed in the UFG 810 module carrier.
Operation of the channel unit is performed via the graphical user interface (GUI) of the
USW 800 control software. Instructions on how to operate are found in the USW 800
operating manual supplied as a pdf in the management software.
Note: The current version of the USW 800 and its operation manual are available free to
download on the Kathrein website "www.kathrein.de".
Install the USW 800 Management software on a computer. Connect your computer's
LAN/Ethernet port to one of the two LAN/Ethernet ports on the UFX 800 (CAT 5 or higher is
recommended, twisted pair). You now have access to all the device parameters.
modules and tighten. Older UFOcompact
®
channel unit
®
modules and UFOcompact
®
5 / 8
modules are DiSEqC™-capable.
®
channel units can be confi gured
®
channel units can
®