first years Indigo Manual De Instrucciones página 8

Section 5 - Stroller Operation and Use - Continued
8. To attach the Graco infant car seat:
A. To remove the toddler seat from the stroller frame,
slide release buttons and lift off seat
1
from the frame.
B. Locate the infant car seat adapter and rotate
arms until they lock into place.
Note: To fold up infant car seat adapter, push release
1
button and rotate arm 2 up.
Repeat for other side.
C. Lower the infant car seat adapter onto the hinges
until it clicks. Infant car seat adapter can be installed
forward or rear facing.
Note: Pull up on the infant car seat adapter to
ensure it is attached.
To remove infant car seat adapter
1
Pull on release tab and pull up adapter
13
2
2
1
2
1
2 .
2
1
Section 5 - Stroller Operation and Use - Continued
D. Lower the Graco infant car seat into the infant car
seat adapter. The Graco infant car seat should latch
onto adapter shown in the detail view.
Note: Pull up on the Graco infant car seat to
ensure it is attached.
E. Route buckle webbing through the belt path on
1
both sides of the infant car seat
buckle . Tighten strap so that the infant
2 3
car seat is held tightly.
9. To remove the Graco infant car seat:
A. Unbuckle the webbing strap over the infant car
seat. Pull release handle 1 on back of infant
car seat. Pull up on infant car seat
remove.
WARNING
Use only the following Graco infant car seats with the infant
car seat adapter:
• Graco SnugRide
®
• Graco SnugRide 32
®
• Graco SnugRide 35
®
3
. Attach the
2 2
1
2
to
2
14
1