Operation Of The Barrier; Table Of The Trasmitter According To The Range Up - EB TECHNOLOGY ACTIVE-S Serie Manual Del Usuario

3

Operation of the barrier

When the barrier is powered, the receiver will automatically recognized how
many rays are available. This operation last for a while then check if all rays
are good working obscuring the last ray or the last 2 rays ( in the opposite side
of the terminal board).
The l.e.d. in the middle of the receiver indicate the status of the alarm when it
is lit on and when it is flashing indicate the quality signal.
LED Signal Quality
pause pause...
pause...
pause
pause
pause
We suggest to check the quality of the signal at the maximum and minimum
brightness above all if the barrier is positionated to the direct sun.
3.1 TABLE OF THE TRANSMITTER ACCORDING TO THE RANGE UP
In the table you can see the power of the transmitter according to the distance with the receiver. We remind you that for
inside we mean all places where there is no direct sun-light.
We suggest to use the high power if the absorption is low and the distance between receiver and transmitter is less than 1
mt.
NO! No good signal
NO! Little good signal
YES! Good Signal
pause...
YES! Very Good
pause...
Signal
DISTANCE
from 0 up to 2 m
from 2 up to 10 m
from 10 up to 30 m
from 0 up to 2 m
from 2 up to 5 m
from 5 up to 15 m
After 2 minutes
of the last alarm, the
l.e.d. flashes
from 1 to 4 times.
LENSES
INSIDE
INSIDE
INSIDE
OUTSIDE
OUTSIDE
OUTSIDE
RECEIVER
FIXING HOLE
SIGNALING LIGHT
SIGNAL OR ALARM
POWER
MEDIUM
HIGH
HIGH
HIGH
MEDIUM
HIGH
13
QUALITY OF THE
STATUS