Safety Regulations - EINHELL GE-CM 18/30 Li - Solo Manual De Instrucciones Original

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, Þ re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 14)
1. Read the directions for use before operating
the equipment.
2. Keep your distance!
3. Caution: Sharp blades! Pull out the safety
plug before carrying out any repair work or if
the power cable is damaged. The blades will
continue to rotate after the motor is switched
o .
4. Protect the equipment from rain and damp
conditions
5. Guaranteed sound power level
6. Dispose of batteries correctly
General safety regulations for this electrical
tool
This equipment is not designed to be used by
people (including children) with limited physical,
sensory or mental capacities or those with no
experience and/or knowledge unless they are su-
pervised by a person who is responsible for their
safety or they have received instructions from
such a person in how to use the equipment safely.
Children must always be supervised in order to
ensure that they do not play with the equipment.
Safety instructions for hand mower
•
Before use, check the mains cable and exten-
sion cable for signs of damage and aging.
Anl_SA_GE_CM_18_30_Li_Solo_ARG.indb 22
GB
•
If the cable is damaged during operation, dis-
connect it immediately from the power supply.
•
Check the machine for signs of damage be-
fore use. Repairs may only be carried out by
our service workshop. If unusual vibrations
occur during use, switch the machine off im-
mediately and pull the plug. Check the cutters
and clean them if necessary. If the machine
continues to vibrate, switch it off, disconnect
it from the mains supply and send it to our
service workshop.
•
The machine must not be tipped whilst it is
being started. Both hands must be on the
handle when you start the machine.
•
Worn parts may only be replaced by our
service workshop. If necessary contact the
service address provided.
WARNINGS
•
Do not touch the cutters until the machine has
been disconnected from the mains and the
cutters have reached a complete standstill.
•
Break the connection with the mains supply
(in other words pull the plug out of the so-
cket):
- whenever you leave the machine unatten-
ded;
- before released a blocked cutter;
- before inspecting or cleaning and before
working on the machine;
- if a foreign body has been struck;
- whenever the machine starts to vibrate
oddly.
•
Carefully read the instructions for how to ope-
rate the machine safely.
- 22 -
24.07.2018 09:28:50