Setting A Timer For Programmed Switch-On And/Or Switch-Off (Weekly Timer) - Olimpia splendid SHERPA MONOBLOC S1 E 6 Instrucciones Para La Instalación, Uso Y Mantenimiento

3. The function remains active even when the unit has been switched off. To deactivate it, set "Weather
depend: Off manually. " ;
4. In the "View" menu, you can see the target value of the climatic curve.
5. The function can still be set if the unit is OFF, but it will only be implemented if the unit is activated.
6. If the relative function is activated (paragraph 8.3), the value of this parameter will be stored in the
memory and automatically reset after any possible voltage failure.
7. The default value for this function is "Off".
4.8. Setting a timer for programmed switch-on and/or switch-off (Weekly timer )
After accessing the "Weekly timer" function, you can
set up to three time bands for each single day of the
week; during these time bands, the unit will work with
the current mode and set-point. Alternatively, you
can assign the "Holiday" value to one day or more; if
the specific "Holiday program" function is enabled, an
operating set-point of 30°C will be automatically set
if you use the check on the delivery water, or 10°C if
you use the ambient air check (installing the specific
air probe accessory).
Clicking on the label for one of the days of the week
allows access to the page for that day, where you can
assign a value to the day, including:
"With" = if the Weekly Timer is active, the system
will perform the programmed access as speci-
fied in the data for periods 1, 2 and 3
"Without" = the Weekly Timer is also active, this
day will not be considered
"Holiday" = if the "Holiday release" is active, dur-
ing this day the set will be kept at 30°C (for water
control) or 10°C (for air control)
By clicking on the label for one of the periods during
the selected day, you can access the period settings
page. The possible period settings are:
"With" = the period describes a time band when
the unit is to be used;; in this case, the labels re-
lating to the start and end times for the period
will also be displayed (which will be set first by
clicking on the time label to be set and then
sliding your fingertip over the time values until
you select the ones required; lastly, press the top
right button to save the data entered)
"Without" = the period will not be used
Weekly timer
Weekly timer: On
Mon: Valid
Wed: Invalid
Fri: Invalid
Sun: Holiday
Mon: Valid
Period 1: Invalid
Period 2: Invalid
Period 3: Invalid
Period 1
Period 1: Valid
Start Timer: 00:00
End Timer: 00:00
Period 1
Period 1: Valid
Start Timer: 00:00
End Timer: 00:00
Tue: Invalid
Thur: Invalid
Sat: Holiday
Mon
22 58
23 59
00 00
01 01
02 02
22 58
23 59
00 00
01 01
02 02
13