To Change The Product To Rear-Side Discharge Mode - Husqvarna LC 353AWD Manual De Usuario

1. Push the cutting height control in the direction of the
wheel and then rearward to increase the cutting
height.
2. Push the cutting height control in the direction of the
wheel and then forward to decrease the cutting
height. (Fig. 28)
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Stay behind the product.
2. Hold the engine brake handle against the handlebar.
(Fig. 29)
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope until you feel some
resistance.
5. Pull with force to start the engine.
WARNING: Do not twist the starter rope
around your hand.
To use the drive on the wheels
• Pull the drive levers in the direction of the handlebar.
(Fig. 30)
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10cm.
• Release the drive levers to disengage the drive, for
example when you go near an obstacle.
To adjust the drive control cable
• Use the adjuster screw to adjust the drive control
cable. (Fig. 31)
• Turn off the engine. Always disconnect the spark
plug before you operate the movable parts.
• Turn the adjustment screw counterclockwise to
tension the wire and increase the speed.
• Turn the adjustment screw clockwise to extend the
wire and reduce speed.
To stop the product
• To stop the drive only, release the drive levers.
• To stop the engine, release the engine brake handle.
(Fig. 32)
To use the product with the grass
catcher
WARNING: Do not operate the product
without a grass catcher installed or without
1242 - 003 - 01.11.2019
the rear deflector closed. Objects can eject
and cause injury to the operator.
1. Lift the rear deflector and remove the mulch plug.
(Fig. 33)
2. Assemble the grass catcher, refer to
the grass catcher on page 12 .
3. Put the grass catcher on the bracket. (Fig. 34)
4. Release the rear deflector and put it on top of the
grass bag frame.
To change the product to mulching
mode
The mulching mode of the product makes grass
clippings smaller. The grass clippings then fall onto the
lawn and scatter across the grass. Mulched grass
biodegrades quickly to give nutrients for the lawn.
1. Lift the back shield and remove the grass bag, if it is
installed.
2. Put the mulch plug into the collector channel.
(Fig. 35)
3. Let the back shield close and make sure it tightly
closes against the mulch plug.
(Fig. 36)
To change the product to rear-side
discharge mode
1. Lift the rear deflector and remove the mulch plug.
(Fig. 37)
2. Install the discharge chute. (Fig. 38)
To empty the grass catcher
CAUTION: Do not drag the bag when you
empty the grass catcher to prevent wear.
1. Lift the grass catcher with the frame handle. (Fig. 39)
2. Remove grass clippings from the grass catcher from
below the handle.
3. Empty grass clippings from the bag with the frame
handle and the bag handle.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
To assemble
13