Star Headlight & Lantern 64 Serie Manual De Instrucciones

64- SERIES BACK-UP ALARMS
IMPORTANT: Please read all of the following instructions
before installing your new back-up alarm.
PLEASE AFFIX THE ENCLOSED WARNING LABEL TO
THE DASHBOARD IN FULL VIEW OF THE OPERATOR!!
 Improper installation my result in serious injury, property damage, or death.
 This alarm should be installed so that it only activates when the vehicle is in reverse.
 Mount the alarm approximately 4 feet above the ground in the rear of the vehicle with the sound
opening outward towards the hazard zone with an unobstructed sound path towards the intended
audience.
 Select a location that provides protection from adverse weather conditions. The sound opening must
be kept clear of dust, mud, or any other foreign material that may prevent the alarm from sounding
properly.
 Use a minimum 18AWG wire for electrical connections and a 5A fuse at the power source, ensuring
both positive and ground connections are dependable.
 If using heavier gauge wire, please obtain an appropriately sized connector.
 Use a ¼"-20 screw to attach the ring terminal to a good chassis ground.
 After installing, while the alarm is operating, measure the voltage both at the battery and at the alarm to
ensure that there is less than a 0.15 VDC loss between the battery and the alarm.
Ensure that the alarm that you are using is loud enough to provide ample warning in the noisiest environments

that it may be used in.
 Test the alarm and inspect all wiring each time you use the vehicle to ensure that it is functioning properly. If it
is not functioning properly, do not operate the vehicle.
 Do not paint or coat the alarm with anything. Doing so may reduce the effectiveness of the alarm.
CAUTION: All of our DC powered back-up alarms are polarity sensitive. All wires
connected to the positive terminal of the battery should be fused at the
battery for their rated load. Testing the alarm before this fuse is properly
installed will void the warranty on the alarm.
These alarms meet or exceed SAEJ994 MARCH 2009 specifications.
-1-
PLIT421 REV. H 5/30/19
Check the label on your alarm for proper voltage,
polarity, current rating, and decibel levels.
Preexisting switch in vehicle
already connected to reverse light
(often activated by the gear shifter)
5 AMP FUSE
BATTERY
If you are installing this alarm on a positive ground
vehicle, DO NOT ground directly to the chassis.
Remove the ring terminal and connect the black
wire directly to the negative side of the battery.
Important! DO NOT wire in parallel with a solenoid or relay coil.
ONE YEAR LIMITED WARRANTY
The manufacturer warrants each new product against factory defects in material and
workmanship for one year after the date of purchase. The owner will be responsible for returning
to the Service Center any defective item(s) with the transportation costs prepaid.
manufacturer will, without charge, repair or replace at its option, products, or part(s), which its
inspection determines to be defective. Repaired or replacement item(s) will be returned to the
purchaser with transportation costs prepaid from the service point. A copy of the purchaser's
receipt must be returned with the defective item(s) in order to qualify for the warranty coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or
the finish. This warranty shall not apply to any light, which has been altered, such that in the
manufacturer's judgment, the performance or reliability has been affected, or if any damage has
resulted from abnormal use or service.
There are no warranties expressed or implied (including any warranty of merchantability or
fitness), which extend this warranty period.
inconvenience, commercial loss or consequential damages, including costs of any labor, are not
covered. The manufacturer reserves the right to change the design of the product without
assuming any obligation to modify any product previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights that may vary
from state to state. Some states do not allow limitations on how long an implied warranty lasts.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
Therefore, the above limitation(s) or exclusion(s) may not apply to you.
Splice the red wire from the back-up alarm into the
wire that supplies power to your reverse light.
REVERSE LIGHT
RED
BLACK
GOOD CHASSIS GROUND
The
The loss of use of the product, loss of time,